Jensen JiMS-198i Bedienungsanleitung PDF herunterladen (Seite 12)

FM STEREO / MONO RECEPTION

1. This unit provides FM STEREO and FM MONO settings. In stereo mode, the unit will

automatically switch to stereo when a FM stereo broadcast is received. The FM ST

indicator turns on.

2. To receive a weak (noisy) FM station, press the MONO/STEREO button once to switch

the FM mode to “MONO”. The FM ST indicator turns off, the reception may be

improved, but the sound is now monaural (MONO).

Note:

1. When listening to an FM program, fully extend the Wire Antenna to insure maximum

tuner sensitivity.

2. The AM receiver uses an external AM loop antenna. If the AM reception is weak,

slightly rotating or re-positioning the loop antenna will usually improve the AM reception.

3. Automatic tuning depends on the signal strength of the broadcasting station, so weak

stations may be skipped. You can manually tune to find the weak stations if a station

gets skipped. With strong signals, the tuner may stop before it reaches the actual

broadcast frequency, so you may need to manually tune for the best reception.

PRESET MEMORY CHANNELS

1. Turn on the radio and press TUNE+ / TUNE- buttons to select the desired channel,

2. Press the MEMORY/SET button once, LED will flash, press PRESET+ / PRESET-

button to select location P01 ~ P10 for setting the channel, press MEMORY/SET button

to confirm.

3. Repeat steps 1 ~ 2 to set more channels. Both AM and FM stations can be pre-set

(up to 10 channels).

RECALL PRESET MEMORY CHANNELS

In AM / FM radio mode, recall the pre-set channels by pressing the

PRESET+ / PRESET – button.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19 20

Keine Kommentare

Jensen JiMS-198i Bedienungsanleitung Seite 12