Jensen JiMS-198i Bedienungsanleitung PDF herunterladen (Seite 16)

You may active the SNOOZE function manually after the alarm sounds by pressing the

SNOOZE button. The snooze time can be adjusted from 1 ~ 30 minutes. The default

snooze time setting is 9 minutes.

SNOOZE TIME SETTING:

1. In standby mode, press and hold the SNOOZE for 3 seconds, the display shows current

snooze time and flashes.

2. Press the UP / DOWN button to increase / decrease the snooze time.

3. Snooze function only effective in 59 minutes., the alarm will not sound after that period.

SNOOZE FUNCTION

1. When the ALARM sounds, press the SNOOZE button to temporally pause the ALARM.

The ALARM will come again after the pre-set SNOOZE time is reached.

2. Pressing the SNOOZE button will display the remaining SNOOZE time left.

3. Manual SNOOZE operation can be repeated again within alarm duration (59 mins).

Actual buzzer duration will be 59 minutes minus SNOOZE time. E.g. after buzzing for

30 mins, 9 mins SNOOZE time selected, remaining buzzing duration will be 20 mins.

You can set the alarm to go off for short catnaps up to two hours without disturbing the

regular alarm settings. The NAP function will wake you up after a short preset period of

time. You can set the NAP alarm time from 10 to 120 minutes.

1. Press the “NAP” button to enter NAP mode, the LED flashes showing ”20”, on the

display. Press the NAP button to show 20-30-60-120-OFF (showing normal clock).

2. Press the UP/DOWN buttons to set exact NAP alarm time you desired between

10 ~ 120 minutes.

3. Wait for 3 seconds to confirm, NAP time will stop flashing and return to normal clock

display.

4. When the countdown time has been reached, there will be a “beeping” alarm sound.

5. Press the snooze button to pause the NAP alarm. Alarm will sound again after snooze

expired.

6. NAP will stop automatically after sounding for 60 minutes if the SNOOZE button is not

pressed. Press the power ON/OFF button once if you want to cancel the NAP alarm

immediately.

SNOOZE OPERATION

NAP OPERATION

1 2 ... 11 12 13 14 15 16 17 18 19 20

Keine Kommentare

Jensen JiMS-198i Bedienungsanleitung Seite 16